Firecube Gen 2
Firecube Gen 2 / Setting up your safe / Setup /

Setup

Please click the link below to view an instructional video on setting up your safe:

Setting Up Your Safe

Firecube Gen 2 / Setting up your safe / Setup /

Installation

Please refer to the links below view installation instructions:

Installing Your Safe Manual

Installing Your Safe Illustration

Firecube Gen 2 / Setting up your safe / Setup /

Registration

To register your Mycube safe please click the link below:

Register Your Safe

Firecube Gen 2 / Setting up your safe / Setup /

Opening & Closing Your Safe

Opening / Closing Door

  1. Press START button. •“------” will be displayed on screen.
  2. Input six-digit code.
  3. "OPEN" will be displayed on screen along with beep sound. Note: Safe must be opened within 3-4 seconds.
  4. Turn the handle to close the door.
  5. Confirm proper closure of safe by turning the handle back to original state.

Firecube Gen 2 / Setting up your safe / Setup /

Reset Code

Your safe can be programmed with either 1 or 2 codes.

  1. Enter current code and open door.
  2. Press white memory button located inside door. “-CodE-“ will be displayed, then “USEr_” will be displayed.
  3. Press 1 then START button. “------” will be displayed.
  4. Enter new 6-digit code. “AgAin” , then “------” will be displayed.
  5. Enter new code again. “In 1” will be displayed.
  6. New code is set. Confirm new code works with door open.
  7. To add second code, Press 2 (in step 3) and repeat steps

Firecube Gen 2 / Setting up your safe / Setup /

Hide or Cancel Code

To hide or cancel your code:

Press START button twice for security mode to hide code. Press START button to cancel code entry.

Firecube Gen 2 / Setting up your safe / Setup /

Sound Effect

Sound Effect ON/OFF:

  1. Open door and press white memory button for 3 seconds. After “beep” message appears, “On-OFF” will be displayed.
  2. Press 0 then START for sound ON. Press 1 then START for sound OFF.

Firecube Gen 2 / Setting up your safe / Setup /

Keypad Lock Mode

Keypad Lock Mode :

  1. Press START for more than 3 seconds until “Act” appears. “Act” message signifies activation of keypad lock mode. Any keypad input will only display “Act.”
  2. To deactivate keypad lock mode, press START for more than 3 seconds until “dEAct” appears. Note: Keypad lock mode will remain despite removal of batteries.